Jump to content


chet

Member Since 22 Sep 2005
Offline Last Active Sep 12 2017 06:02 PM
-----

Posts I've Made

In Topic: 06 Matrix Idle Speed

11 March 2014 - 06:22 AM

OK guys thanks, i will check the vacum lines after work today, no the check enging light did not come on only drove it 1/2 mile so far, i do have a CAI on the car, been on there since 2009 no issues, i do have an extra air filter for the end of the tube, well i will find out if the CEL comes on again.

 

   thanks

 Chet


In Topic: 06 Matrix Idle Speed

10 March 2014 - 05:59 PM

not sure what you mean by clearing the cel, if you mean the code, yes i put my scanner on and did the erase codes, as for vacum lines, where di i start looking for these lines,

 

  Chet


In Topic: Turn Signals

05 September 2012 - 06:03 PM

Afte calling the Toyota dealer there are no options for a different flasher, while I was at work today I picked up a small beeper power requirements are 3 to 24 volts, so not I have to try to figure out what wirea are what behind the fuse panel and tie this little sound device in. is there anywhere online i can find a wiring schematic of the fuse panel and the dash ect.

Chet

In Topic: Srs Light Won't Go Out

09 April 2012 - 08:19 PM

After thinking about the srs light. I think I may know what happened, a few weeks ago I was going out of a steep driveway, I have a trailer hitch on my car and I scraped pretty hard, wonder if this set of my rear srs module. would the Actron OBD II scanner pick this up, and where is the module located.

Chet

In Topic: Strut Replacements

21 March 2012 - 11:16 AM

Callled a local NAPA dealer today, I ask for KYB struts, they said they have a KYB shock formally called the GR2 in stock, they have the same KYB PN 235703 and 235704 and are priced rather reasonable at $104 each and the replacement dust covers are $17 each, any comments.


Chet